top of page

Die Cast Lubricant Pump

 

For even flow of die lubricant controlled with pressure feedback control

IPCS.png

Pump

Release agent discharge

Release agent

tank

  1. Piston pressurization occurs inside the cylinder of the pump body through the use of a servo motor

  2. The pressure inside the cylinder is measured with a pressure sensor

  3. Servo pack matches the pressure in the cylinder to the target pressure

  4. The pressure inside the cylinder remains constant and suppresses variations in discharge rate

Actual Performance Data

 

Target pressure

1. Before discharge

2. Discharging

 

3. After discharge

 

Pressure feedback ON: Orange

Pressure feedback OFF: Blue

  1. Before discharge ... Pressure remains stable and consistent with target

  2. During discharge ... Pressure drop is suppressed

  3. After discharge ... Pressure remains stable and consistent with target

 

  1. Improved Quality: By eliminating pressure unevenness in pressure feeding of the die lubricant, RYOEI's pump suppresses variation in the discharge amount and contributes to the stabilization of the quality of die-cast type products.

  2. Adapts to Variations in Spray Pattern: Pressure can be controlled without being affected by variations in spray pattern or the number of simultaneously spraying nozzles. 

  3. Simple Setup: Since air is not used as the power source, the number of devices can be reduced and ease of maintenance can be expected to improve.

  4. Traceability: Discharge rate can be measured for each cycle.

 

Benefits

 

 
bottom of page